1. Adopts whole steel welding structure, have the enough strength and rigidity.
      2. Hydraulic transmission, machine tools on both ends of the oil cylinder resettled in slide block, drive directly sliding work.
      3. The slider synchronous organizations to adopt twisted axis force synchronization.
      4. Adopting mechanical block structure, stable and reliable.
5. The slider trip maneuvering fast adjusted, manual adjustments counter displays.
6. Oblique wedge type the deflection of compensation to ensure to gain higher institutions, bending precision.
Bending machine including stents, worktable and clamping board, workbench placed scaffolding, workbench by base and linking piece constitute, base through the hinge and clamping plate connected, base by seat shell, coil and flats composition, coil on seat, within the shell of sag overburden have cover. Top sag,
When used by wire pair coil electrify, after electrify for linking piece produce gravitation, so as to achieve linking piece and base plate of clamping between. As a result of the electromagnetic force clamping, making the linking piece can be made into various workpiece with requirement, and can be side wall of workpiece machining.
Bending machine usage:
According to the ordinary hydraulic bending machining Q235 sheet to do simple introduction:
1, first is switch on the power, on the control panel, click open keys switch pump start-up, so you can hear the voice of oil pump rotation. (when the machine from action)
2, travel adjustment, bending machine use must pay attention to adjust trip, in bending former must commissioning. Bending machine mould downward to the bottom must ensure that have a thickness clearance. Otherwise it will cause damage to the mold and the machine. Schedule regulation is also has an electric, quick adjustment and manual stomach tone.
3, and bending noth choice, general should choose thickness of eight times the width of the slot. If, in the process of sheet metal bending 4mm required to choose 32 around slot.
4, after block material adjustment generally has electric, quick adjustment and manual adjustments method with plate shears.
5, trample down pedal switch began to bend, bending machine and plate shears different, can at any time to loosen, loosen the foot bending machine will stop on the downside. Continue to,
Bending machine maintenance and maintenance:
The machine maintenance or wipe machine before, should the upper die alignment lower die down after shutdown, until after work, such as to boot, or other operations, should be in manual mode selection, and ensure security. Its maintenance content as follows:
1, hydraulic oil
A. weekly to check the gas oil level, such as hydraulic system after repair should also check, oil level below oil window shall charging hydraulic oil,
B. the machine used hydraulic oil for ISO HM46 or DTE25 MOBIL,
C. xinji work after 2000 hours should replace the oil, then everyday work 4,000 to 6,000 hours after should replace the oil, every time, should replace the oil tank cleaning,
D. system should be in 35 oil temperature ¡æ ~ 60 ¡æ between, shall not exceed 70 ¡æ, such as high will cause oily and accessories metamorphic damage.
2, the filter
A. at each change oil, filter should be replaced or clean thoroughly,
B. machine tools have related alarm or oily sordid other filters abnormalities, should be replaced,
C. fuel tank air filter, every 3 months inspect cleaning, best 1 year replacement.
3, hydraulic components
A. monthly clean hydraulic parts (substrate, valves, motor, pump, tubing, etc.), prevent dirt into the system, cannot use cleaner,
B. xinji use after a month, check the tubing bending deformation place to have, if any abnormal must be changed, use two months later, should tighten all accessories joints and conduct such work should be shutdown, system without pressure